Experience and Accomplishment

Clemson University F1TENTH Project Leader - (May 2020 - Nov 2020)

' I am the team leader for Clemson University F1TENTH project. Our team participate in 2020 IFAC F1TENTH competition and finished top 5 with only 3 weeks of research and development. '

My duties include: 1. Algorithm research & development on vehicle control and planning 2. System architecture design and code review for the team. 3. Communicating and interacting with competition organizer.
Competition result: https://f1tenth.org/ifac2020.html
https://blogs.clemson.edu/mechanical-engineering/clemson-team-speedtiger-finished-in-top-5-finalists-at-the-grand-prix-competition/

Clemson Autonomous System Team Graduate Advisor - (June 2018 - Nov 2020)

' I was graduate advisor for Clemson Autonomous System Team to compete in Clemson COVID challenge competition. With the great effort of the team members, we were awarded with the COVID Challenge Excellence Prize. '

My duties include tutoring basic ROS development skill and drone dynamics to new team member, as well as doing autonomous system R&D .
Competition result: https://blogs.clemson.edu/mechanical-engineering/me-team-participates-in-the-clemson-covid-challenge/

Clemson Formula SAE Aerodynamic Designer - (June 2017 - July 2019)

' I joined Clemson Formula SAE Team in June 2017 as a Aerodynamic Engineer. It is one of my greatest team engineering team work experience by far. With the great efforts of all divisions and team members, we managed to rank 19th in 108 teams in Michigan Formula SAE International competition in 2019. '

https://blogs.clemson.edu/mechanical-engineering/clemson-performs-well-in-formula-sae-competition/

Aerodynamic Engineer (June 2017 - July 2019)
- Design 2018's car's front wing to meet downforce, drag force, y+ value requirement. (ANSYS Fluent and ANSYS parametric design tool)
- Design 2019's car's rear wing to meet downforce, drag force, y+ value requirement. (ANSYS Fluent and ANSYS parametric design tool)
- Research and Development: Optimize sidepod geometry to maximize the heat transfer while minimize drag.
Wind Tunnel Testing Engineer
- Design and build wind-tunnel test platform. Use LabVIEW MyRio for data acquisition. Use MATLAB to perform data processing and result analysis.
- Validate ANSYS CFD simulation result with wind tunnel testing data to improve simulation process.